Icom IC-756PRO HF/50Mhz/100W Amateur Ham Radio w/cord,Microphone,manual,Warranty

Description

Icom IC-756PRO HF/50Mhz/100W Amateur Ham Radio w/cord,Microphone,manual,Warranty
Description
・ Main body
・ DC code
・ Warranty (not stated)
·instruction manual
* Please see the photo for accessories other than the above.
・ When measured with a terminal wattmeter, it was as follows at CW.
★ HF band: Approximately 100W (FM in the 29MHz band is approximately 100W)
★ 50.000MHz: Approximately 100W (FM Approximately 100W)
・ We have not confirmed by connecting the antenna.
-The 1.8MHz band, 3.5MHz band, and 7MHz band have been expanded.
* This is not the revision for 2020.
・ When the signal of -73dBm was input from SG, the preamplifier was turned off and the result was as follows.
★ 1.80MHz: Approx. S8
★ 3.60MHz: Approx. S8.5
★ 7.10MHz-24.89MHz: Approx. S9
★ 28.0MHz: Approx. S8
★ 50.0MHz: Approx. S9
・ It is unknown when to purchase and how to incorporate options.
-All reset has been completed.
-There is no gully in AF gain and squelch.
-The auto antenna tuner worked when I checked it with a 100 ohm (SWR2.0) dummy load installed.
-The external antenna tuner connection on the back of the main unit is wobbling and is about to come out a little.
-There are no noticeable scratches on the main body, and it is in a relatively clean state.
・ Please check the photo for details such as appearance.
-There is no tobacco odor.
(Caution) The handling in CW mode is as follows.
According to the instruction manual, there are three types of break-in modes: full, semi, and OFF.
When I checked in semi-break-in mode using my straight key key and paddle key, using both the back and front key connections of the main unit, the transmission operation by the key and the item description column for all bands I checked the transmission output described in.
Also, even when the break-in mode was turned off, I was able to confirm the operation by pressing the power key with the TRANSMIT button under the power button in the transmission state.
Page 29 of the instruction manual attached to this product, "Operation in CW mode"
There is the following description in the item of "How to send".
"Connect a key or external electronic keyer to his KEY jack on the back panel (the paddle with polar terminals is his ELEC-KEY jack on the front panel) and press the TRANSMIT button to put it in the transmit state.
Keying with a key will fire a CW wave. "
According to the above description, this model is a "handheld microphone PTT switch".
With one of the "TRANSMIT buttons at the bottom of the power button",
It is a specification to send by using either "electric key", "external electronic keyer", or "paddle with polarity on the terminal".
As mentioned in the explanation, there is one point to worry about. The output with the handheld microphone in CW mode cannot be confirmed. It is not possible to check the output of the radio in CW mode. If you connect a power meter with LSB / USB / FM, you can check the output of 100W. However, it seems that there is no problem with the output when the key is connected and 100W is output with CW. Please note this one point in advance. I inspected the other parts, but there are no abnormalities. After that, one power switch lamp does not light up. Please note the above in advance.
The output of 100W has been confirmed with the SX-200 of each band diamond. There is an output of 100W without any abnormality. please note that.
The output in CW mode on the radio side cannot be confirmed with the handheld microphone, but if you connect the electric key, 100W will be output in CW without any problem. After that, the power switch lamp does not light up. From the above points, it works, but there is a problem.
Payment
Please pay within 3 days after the order is completed.
We will ship the item 10 business days after your payment clears.
Shipping
We ship it from Japan by Japan post International or FedEx. We attach the tracking number.  Shipping is only available to the address registered in eBay.
Please note that any address not registered in eBay is not acceptable to ship
.
International Buyers - Please Note:
International Buyers - Please Note :
Import duties, taxes, and charges are not included in the item price or shipping cost. These charges are the buyer's responsibility. Please check with your country's customs office to determine what these additional costs will be prior to bidding or buying.
Dear Customer
Thank you for visiting my listing page. Our store sell a lot of goods from Japan and provide courteous and responsive service. If you are looking for a particular item that is not in my listing, please feel free to ask us.
We will look it for you.
Thank you again.
Provided by HARU eBay listing tool.